Why do I receive 'Data type mismatch' error when using a VCO in simulink?
Show older comments
This is the error:
Data type mismatch. Input port 2 of '[FileName]/Frequency of single tone/Calculate single tone
frequency/Set to Zero if previous time was zero' expects a signal of data type
'double'. However, it is driven by a signal of data type 'boolean'.
Edit: Attached the simulink model.
Answers (0)
Categories
Find more on Simulink in Help Center and File Exchange
on 10 Mar 2017
on 10 Mar 2017
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
