Simscape gas pipe element causes initialization errors
2 views (last 30 days)
Show older comments
Ryan Takatsuka
on 20 Jul 2017
Answered: Ankitha Kollegal Arjun
on 25 Jul 2017
I have a Simscape model with a long thin (an inner diameter of 0.030") tube in the middle. When the tube is shorter (less than about 10 inches in length) the simulation runs perfectly, but when I change the tube to become longer (about 20 inches in length) I receive the following error message:
"Transient initialization, solving for consistent states and modes, failed to converge. Nonlinear solver: failed to converge, residual norm too large."
The actual tube is very long (multiple feet), so I don't know how to accurately model this in Simscape without getting error messages.
0 Comments
Accepted Answer
Ankitha Kollegal Arjun
on 25 Jul 2017
It could be a modeling issue. Please use the troubleshooting steps mentioned in the following documentation to figure out any discrepancies in the model:
0 Comments
More Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!