How to edit a read only property (FEMesh data of PDEModel)?
6 views (last 30 days)
Show older comments
Fergus McIlwaine
on 28 Aug 2017
Edited: Svetlana Pease
on 30 Aug 2017
In an attempt to solve my own problem I need to edit the values of the PDE model created using the PDE toolbox.
I am attempting to to convert [p,e,t] mesh data to the FEMesh object.
When I try I get the following error
You cannot set the read-only property 'Nodes' of FEMesh.
Below is the code
function Attempt1 = LegToNew(dl,model)
% Attempt to Convert [p,e,t] to FEMesh. dl is the decomposed geometry.
Hmax = 0.3;
Hgrad = 1.9;
[p,e,t] = initmesh(dl,'Hmax',Hmax,'Hgrad',Hgrad,'JiggleIter',10);
figure(1);
pdemesh(p,e,t);
% Form model with same sized cells
generateMesh(model,'Hmax',Hmax,'Hgrad',Hgrad,'JiggleIter',10);
model.Mesh.Nodes = p; % Insert node data. Error occurs here.
model.Mesh.Elements = t(1:3,:); % Triangle points
% model.Mesh.MaxElementSize = ; % Unsure
% model.Mesh.MinElementSize = ; % Unsure
model.Mesh.GeometricOrder = 'linear';
figure(2)
pdeplot(model);
If I'm able to successfully convert [p,e,t] to FEMesh data my plan is to refine a subdomain and then convert the newly created mesh data into the PDEModel.
Thank you.
0 Comments
Accepted Answer
Svetlana Pease
on 30 Aug 2017
Edited: Svetlana Pease
on 30 Aug 2017
Unfortunately, converting a [p,e,t] mesh to a FEMesh object is not supported.
Regards,
Svetlana Pease
Technical Writer, MathWorks Documentation Group
0 Comments
More Answers (0)
See Also
Categories
Find more on Geometry and Mesh in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!