DC Motor position control: Downward slope is much less than upward
2 views (last 30 days)
Show older comments
I am trying to make this motor follow a sine wave however the downward slope of position won't match upwards. For example, it will follow the sine wave from 0 to 1 but will not follow closely enough from 1 to 0. I believe it has something to do with the motor block but I'm not sure. Run the program then look at scope 5 for position compared to sine wave. Thanks for any help in advance.
0 Comments
Answers (1)
Aveek Podder
on 20 Oct 2017
Hi,
It seems the model tracking the input signal properly for a low frequency sine wave input(5 Hz). I believe the control-loop needs to be tuned.
0 Comments
Communities
More Answers in the Power Electronics Control
See Also
Categories
Find more on Motor Drives in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!