We have contacted Parrot regarding this issue and they have provided us a workaround to resolve this issue. The fix has already been published in R2017b in the support package version 17.2.3. Please upgrade your support package version to 17.2.3 in R2017b and perform the hardware setup for Parrot Rolling Spider once more.
If you do not wish to upgrade your support package, you can follow the below steps to resolve this issue.
- Connect the Parrot Rolling Spider drone to PC. Wait for the LEDs to stabilize to RED and GREEN.
- If you are working in Windows PC, install RNDIS as mentioned in this link. Please note that drone has a timeout period of approx 60 seconds after which it automatically disconnects from PC. Hence please complete the RNDIS installation as fast as possible.
- Open Windows command prompt. Execute the below command in the command prompt as shown in the snapshot.
If you get an error 'telnet' is not recognized as an internal or external command, operable program or batch file, you need to enable telnet in your Windows PC. Follow the instructions in this MATLAB answer to enable telnet in your PC.
If the command prompt displays the message Connecting to 192.168.2.1...... for a long time and then it fails, it might be that the drone has timed out or the RNDIS installation has not gone through.
Reconnect the drone and repeat Step 3. If you still get same error, you need to install RNDIS on the host computer again as mentioned in Step 2. Complete the RNDIS installation as fast as possible.
On successful execution of the command you should see a command prompt window as shown in the snapshot.
- On the Delos prompt in the command window, execute the below command
echo "1.99.2" > /version.txt
This would create the missing version.txt in the root folder of the drone, that is required for the firmware update to be successful.
If you get any write permission error while executing this command, try rebooting the drone and repeat the above steps.
After successful execution of the above command, complete the hardware setup screens in MATLAB. They should go through without any issue.