real-time standalone mode file transfer

4 views (last 30 days)
I use matlab 2018a. The target is a mini-board with intel J9100 processor. With the standalone mode, the target starts correctly. But after I transfer the application file "*.mldatx" to target, the name of application file is modified automatically to force the extension of file name to be "*.mld", which can be executed by the real-time kernal and prompt "error unpacking application". I think it is caused by the incorrect extension of file name. How to make the real-time kernal to support long extension name?
  5 Comments
Pika
Pika on 28 Sep 2018
If the extension of file name is restricted to 3 letters, I think real-time should generate application file name satisfying it. If I force the extension of file name to be 3, the real-time kernal can not run the application. I have bought a Speedgoat computer and I should try on it immediately. If there still exists this problem, I can only use Matlab 2016.
Walter Roberson
Walter Roberson on 28 Sep 2018
Sorry, I am going by documentation here; I do not have a system to test with.

Sign in to comment.

Accepted Answer

Pablo Romero
Pablo Romero on 20 Dec 2018
This is a known bug. For more information refer to the bug report below:
Note that an upgrade to Speedgoat Library version 8.24.0.1 (or later) is required after installation of MATLAB R2018a Update 4.
Hope this helps.
Pablo

More Answers (0)

Categories

Find more on Real-Time Simulation and Testing in Help Center and File Exchange

Products


Release

R2018a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!