Run transmitter and receiver model in 1 model or 2 separate model in parallel

I have only 1 set of the hardware boards(AD-FMCOMMS4-EBZ(which is AD9364) and Zedboard). so I will run both transmitter and receiver on Zedboard.

1) if I run transmitter and receiver in one model in Simulink, I could receive the discontinuous sin wave shown in the following picture.

2) if I run transmitter and receiver in 2 different models in Simulink in parallel, I could not receive any data from receiver. This is really weird. I cannot figure out the reason and difference.

The example models I am using are:

https://ww2.mathworks.cn/help/supportpkg/xilinxzynqbasedradio/examples/frequency-offset-calibration-using-analog-devices-ad9361-ad9364.html

Transmitter model: zynqRadioFrequencyCalibrationTxAD9361AD9364SL

Receiver model: zynqRadioFrequencyCalibrationRxAD9361AD9364SL

*At present my questions are: a) how to receive continuous sin wave from receive?

b) why could I not receive any data from receiver if I run transmitter and receiver separately and in parallel?*

By the way: I am able to use command and Spectrum Analyzer to make sure transmitter is running while I start receiver.

I am suspecting whether there might be some special settings in Model Configuration Parameters

Answer 1

[Paul]

Hi Ardeal,

The answer I gave to your other post should cover this question too. Link.

Hopefully that helps you.

[Ardeal Liang]

Got it! Many thanks!