Is there a switch that turns on for a specific amount of time? That does not depend on the system's time.

Is there a switch in simulink that turns on for a specific amount of time then turns off?

For context, the orange signal runs for 1s and I want a switch that becomes closed when the orange signal < 0 and sends a yellow signal that runs for 0.5s.

Currently i am using a switch that is set at >= -0.00001 (when the signal goes down)

Any help is appreciated! Thank you!

[Aggariyo Wanagiri]

I need something like this. This is done manually with a pulse generator, but I need it to be conditioned by the orange signal.

Answer 1

[Shivam Sardana]

An Enabled Subsystem can be used for your requirement. Whenever orange signal is less than 0, an enabler can be set to 1 and send to Enabled Subsystem which runs yellow signal for 0.5 seconds. A Switch can be used whose output can be passed to Scope.

[Aggariyo Wanagiri]

How do I run the yellow signal for o.5 seconds or 5 seconds? I see no time setting in the enabled subsystem.