I reinstalled Ubuntu 16.04 LTS WSL, re-cloned the PX4 firmware, reinstalled the latest firmware to the Pixfalcon, and followed all the steps very thoroughly, paying a great amount of attention to the "What to Consider" in the sidebar. I still cannot proceed past the "Firmware upload failed: Firmware image not found. Please build the firmware again" error.
SOLVED: Unable to Upload Firmware to Pixhawk; Firmware image not found
14 views (last 30 days)
Show older comments
Joshua O'Reilly
on 31 May 2019
Commented: Ashish
on 6 Oct 2023
EDIT: SOLVED
See the bottom comment for the solution
---
I've been following the setup steps for the PX4 Autopilots Support from Embedded Coder package. I was able to succesfully build the firmware (nuttx_px4fmu-v2_default.cmake), however when trying to upload it to the actual board, I get the following error:
Firmware upload failed: Firmware image not found. Please build the firmware again.
I've rebuilt the firmware a dozen or so times now, including the lpe variant, and I always get this error. The COM port is properly identified, and I used the appropriate version for everything (Ubuntu 16.04 WSL, PX4 v1.8.0, MATLAB R2018b along with all required packages). In the command prompt it indicates
BUILDSTARTING_31-May-2019_10-08-01
CMAKE Config selected : px4fmu-v2_default
After building the firmware. Any clue why this is happening/how to resolve it?
I'm running MATLAB on Windows 10 1803, using a Pixhawk board (condensed version of Pixhawk 1)
6 Comments
Accepted Answer
More Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!