How do I find out what toolboxes my Simulink model requires?

I tried to use the following command:

tbxes=dependencies.toolboxDependencyAnalysis("flight_Simulator_V3_anime")

But had the following error message returned:

Insufficient number of outputs from right hand side of equal sign to satisfy assignment.

Error in dependencies/toolboxDependencyAnalysis>i_findInfo

Error in dependencies/toolboxDependencyAnalysis>i_findToolboxes

Error in dependencies/toolboxDependencyAnalysis

Did I do something wrong?

[Fangjun Jiang]

Try the example first.

files_in={'vdp'};
names = dependencies.toolboxDependencyAnalysis(files_in)

[Ariel Kantor]

Hi Fangjun Jiang, I have tried it and recieved the same error. My model is similar to the flight simulation model shown here: https://www.mathworks.com/help/aeroblks/hl-20-project-with-optional-flightgear-interface.html

It's also possible I've accidentally included an Arduino toolbox block in the model, however it is not used. Could this be relevant?

[Sahithi Kanumarlapudi]

Hi,

I would suggest you to check if 'tbxes' variable is not defined anywhere else. That might also cause issue sometimes.

[Fangjun Jiang]

@Sahithi, what is your advice??? 'tbxes' in his command is a return variable. Be mindful that your "STAFF" badge carries weight.

[Fangjun Jiang]

If the example gives you the error, then probably there is problem with your MATLAB/Simulink installation. Simulink is the only required toolbox to run this.

Answer 1

[Codrut Alexandru Dan]

use tbxes=dependencies.toolboxDependencyAnalysis({'flight_Simulator_V3_anime'}). commas are wrong