SimPowerSystems Error "No Voltage/Current/Machine Block" with a Frequency matching Phasor Sim Frequency

I have setup a simpowersystems 4 synchrounous machine model set at 60 Hz. When I try to run the model I receive an error message that says "There is no voltage source, current source, or machine block with a frequency matching the Phasor simulation frequency"

The setup is very similar to one of the synchronous machine example models in simulink. I have defined the system frequency in the mahcine as 60 Hz under teh parameters tab. Can anyone advise how to fix this issue.

Answer 1

[shi wenbo]

This error is caused by some unconnected element existing in the model, like Line68-71 and BUS71 in the following picture.

[Danish Khatri]

This solved the problem!

Answer 2

[hongyi Huang]

I recieved the same message when I just remove the breaker block and fault block from the PSS example model.Actually,I don't konw what is the Phosor simulation.It is my pleasure if any one can advise to me.

Answer 3

[ning wang]

天堂

Answer 4

[Henok Ayele Behabtu]

i solve such type of problem when i simulate wind turibne generator system grid intgration simulation case, the system is was running at fault condition(i connect the three phase fault ) but when disconnect the fault and run the simulink the error was happen.

when i remove the three phase fault from the simulink window it works, so dont run the simulation simple by disconnecting any device from your network.