Powergui scope does not show scope

I made a new simulink model with rectifier and inverter and powergui. i logged the data in the workspace but somehow only the previous scope data shows in the p[owergui input signal.

the scope input of the new model doesnot show up. i dont know why???

[Sulaymon Eshkabilov]

Can you share your model to follow your question correctly?

[shalaka sitre]

[shalaka sitre]

so i made one simanulation of a multidrive system before consisting of 20 drives oin parallel. and recorded the THD of the system using powergui with input scopes from all the drives.

Then i went ahead and designed this srive as a single unit but the powergui doesnt seem to get the input from the scopes present oin this simulation.

i only get input data from the scopes of the previous simulation , even after refereshing it it doesnt comeup!

i dnt knw what to do

[shalaka sitre]

@Sulaymon Eshkabilov please see