Simulink coder with PID - Algebraic loop when using antiwindup
2 views (last 30 days)
Show older comments
I'm using simulink coder to generates code for the STM32 microcontroller. My model uses a couple of PIDs and everything works fine so far. However, i noticed that i need to have some sort of anti windup active in the PIDs. I tried to use both the back-calculation and clamping options, but in either case i get the following error:
Algebraic loops are not supported in generated code. Use the 'ashow' command in the Simulink Debugger to see the algebraic loops
I'm surprised that there is any algebraic loop in the first place since the anti windup error feedback goes through an integrator (for back-calculation).
Is there any way to work around this?
Thanks, Alex
0 Comments
Answers (1)
Arkadiy Turevskiy
on 30 Aug 2013
In the block dialog, make sure you have "Forward Euler" selected for both integrator method and filter method.
HTH.
0 Comments
See Also
Categories
Find more on Discontinuities in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!