contour plotting in matlab
Show older comments
Hi
I have plotted a scattered plot and a contour plot (figure attached below). However, the contour plot has unusual curvy edges as marked in the figure. How to avoid these curvy edges and make a smooth color variation.


5 Comments
Walter Roberson
on 28 Jun 2021
After you interpolate, use a low-pass filter?
Bjorn Gustavsson
on 28 Jun 2021
What did you see when you looked at the triangulation around one of the intersections between the circle-sections and the horizontal lines?
mukesh bisht
on 28 Jun 2021
Edited: Walter Roberson
on 28 Jun 2021
Bjorn Gustavsson
on 28 Jun 2021
You should first figure out why you get these "pricks" in the first place. Then figure out a way to handle that cause. Here's what you should do, explicitly.
On top of your scatterplot plot the edges of all the triangles created by the triangulation used by delaunay, which is used inside the griddata/scatteredinterpolant/triscatteredinterpolant functions, like this:
tri = delaunay(x,y);
clf
% Your call to scatter goes here
hold on
edges = [1 2;2 3;3 1];
for i1 = 1:size(tri,1)
for i2 = 1:3
h = plot(x(tri(i1,edges(i2,:))),y(tri(i1,edges(i2,:))),'b','linewidth',2);
drawnow
set(h,'linewidth',1)
end
end
Then you zoom in onto the edge between the "all-blue" circle-sectors and the lines - there you will see the cause of your problem.
Bjorn Gustavsson
on 28 Jun 2021
Well I guess you could also go for a non-linear diffusion-filter but that will be for later when other means to handle your problem is exhausted.
Answers (0)
Categories
Find more on Surface and Mesh Plots in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!