How can I reverse the y-axis when I use the IMAGE or IMAGESC function to display an image in MATLAB?
725 views (last 30 days)
Show older comments
MathWorks Support Team
on 29 Jul 2010
Edited: madhan ravi
on 3 Feb 2019
I execute the following commands to display an image using the IMAGESC function:
load clown
clims = [10 60];
imagesc(X,clims)
colormap(gray)
The y-axis runs from the top of the image to the bottom. I would like to reverse the y-axis so that it starts at the bottom of the image and runs to to the top.
Accepted Answer
MathWorks Support Team
on 29 Jul 2010
This change has been incorporated into the documentation in Release 2009b (R2009b). For previous releases, read below for any additional information:
The first row of pixels is normally at the top of an image. By default, the IMAGE and IMAGESC functions invert the y-axis direction when the image is displayed on an axes by setting the 'YDir' property to 'reverse.' To invert the y-axis direction, set the 'YDir' property to 'normal', as follows:
load clown
clims = [10 60];
imagesc(flipud(X),clims)
colormap(gray)
set(gca,'YDir','normal')
2 Comments
Royi Avital
on 1 May 2018
The problem is doing this flips the data as well. How could one only flip the axis yet not how the data is displayed?
Mary Abbott
on 9 May 2018
Hi Royi,
Only setting the 'YDir' property of the axes to 'normal' will flip how the y-axis is displayed, causing the image to appear upside down. To account for this, we use the "flipud" function to flip the image back. Essentially, we are flipping it horizontally twice, so the end result should not appear flipped.
More Answers (1)
BHANESH BHADRECHA
on 2 Nov 2015
Edited: madhan ravi
on 3 Feb 2019
set(gca,'YDir','normal')
0 Comments
Categories
Find more on Introduction to Installation and Licensing in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!