how to connect sum block in Simulink to both ideal switches
5 views (last 30 days)
Show older comments
Emad Alhani
on 30 Jul 2020
Answered: Mohsen Aleenejad
on 30 Jul 2020
how to connect sum block in Simulink to both ideal switches as shown in figure
2 Comments
Mohsen Aleenejad
on 30 Jul 2020
Hello Emad,
This ideal switch belongs to the Specialized Power Systems library. Terminals 1 and 2 cannot be connected to the signal ports. You should find power components/parts for those terminals like this:
Mohsen Aleenejad
on 30 Jul 2020
For your model, probably this is what you need to do:
Good Luck
Mohsen
Accepted Answer
Mohsen Aleenejad
on 30 Jul 2020
This ideal switch belongs to the Specialized Power Systems library. Terminals 1 and 2 cannot be connected to the signal ports. You should find power components/parts for those terminals like this:
For your model, probably this is what you need to do:
Good Luck
Mohsen
0 Comments
More Answers (1)
Joel Van Sickel
on 30 Jul 2020
Hello Emad,
the issue here is that there are two types of wires that you are using. One is a standard simulink wire, which has the arrows indiciating flow of data. however, the other connections you are trying to use are actual electrical connections. These were designed so that you could build an actual circuit, that interacts with the more logical and math based simulink models. If you want to bring a signal from simulink into your circuit with a sum block, I would recommend using a controlled voltage source. https://www.mathworks.com/help/physmod/sps/powersys/ref/controlledvoltagesource.html
In the matlab control panel, you could type this: power_controlvolt
in order to open an example of how to use this type of block.
Regards,
Joel
0 Comments
Communities
More Answers in the Power Electronics Control
See Also
Categories
Find more on Switches and Breakers in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!