Community Profile

photo

Mohsen Aleenejad

Last seen: 2 days ago |  Active since 2020

Contact

Statistics

  • Knowledgeable Level 2
  • First Review
  • First Answer
  • Revival Level 1

View badges

Content Feed

View by

Answered
SimPowerElectronicsのブロックを改造してダイオードと素子の電流を出力する改造を施した際に保存できないエラーを解除する方法
Hi, I have done the same modifications on my side, and it did not throw any errors. I just simply unlink this block from he l...

3 months ago | 0

Answered
실행할 입력 인수가 추가적으로 필요합니다. 무엇을 넣어야 하나요? Additional input arguments are required to run. What should I put in?
Hi, When you run the MATLAB script with: function x = key2note(A, keynum, dur, fs) tt = 0:(1/fs):dur-1/fs; freq = 440 * 2^(...

3 months ago | 0

Answered
Does changing the phase of the variable phase shifter in MATLAB Simulink causes the amplitude of the continuous wave to change as well?
Hi, If by continuous wave, you mean "I", then, answer is yes. However, it makes more sense that the amplitude is sqrt(I^2+Q^2) ...

3 months ago | 0

Answered
Further understanding into Hall Validity & Hall Decoder block
How accurate is the 'Hall Validity' block in validifying the Hall sensor? The Hall Validity block works on every Hall ...

4 months ago | 0

Answered
Turn-on of the N-channel IGBT
Are you sure those parameters in the N-Channel IGBT were set properly? This happens due to the parameters you set for your IGB...

4 months ago | 0

Answered
Further understanding into Hall Validity & Hall Decoder block
Hi Alex, 1-If you search for "Hall Validity" or "Hall Decoder" into MATLAB search bar, you'll find all of the related docs. ...

4 months ago | 0

Answered
Has anyone done a project with the Texas Instruments TMDSSOLARUINVKIT "Solar Micro Inverter Development Kit" module?
Hi @Andres Lopez, Here the issue is that the Solar Invereter example was created by R2018b and you are using an earlier versi...

2 years ago | 2

Answered
How to build op amp
Hi Khald, Do you have access to Simscape library? You can find the built in block in Simscape library. Best Mohsen

2 years ago | 0

Answered
q- d- currents of PMSM drive in Delta configuration
Hi Tom, Could you please tell me if these numbers are the exact values you observe? If not could you please provide the exact...

2 years ago | 1

| accepted

Answered
how to connect sum block in Simulink to both ideal switches
This ideal switch belongs to the Specialized Power Systems library. Terminals 1 and 2 cannot be connected to the signal ports. Y...

2 years ago | 0

| accepted

Answered
AC/DC Three-Level PWM Converter
The reason is that the topology is not physically able to follow the negative reference. The load consists of two parallel resis...

2 years ago | 0

Answered
Embedded Matlab function for Microcontroller modelling with PWM
Hi Eleni.T, The correct answer to this question really depends on your final design. What paramters are being controlled and wh...

2 years ago | 0

| accepted